Valve Flush VF-3
Rapid acting biodegradable fluid for industrial use, especially intended for oilfield valves. Formulated from solvents, semi-synthetic fluids, dispersants and detergents to quickly remove unwanted deposits. Highly penetrative to clean seal faces and sealant/lubricant passageways.
Industry Applications:
Key Features
Applications
Served Industries
Technical Data Sheet
Typical technical characteristics and operating guidance for Valve Flush VF-3.
| Property | Test Method | Typical Value |
|---|---|---|
| Appearance | Visual | Low viscosity fluid |
| Composition | — | Solvents + semi-synthetic fluids + dispersants |
| Biodegradability | — | Yes |
| Penetration | ASTM D217 | High |
| Application | — | Valve flushing and cleaning |
| Packaging | — | Drum/Aerosol |
Operating Parameters
Temperature Range
Refer to data sheet
Viscosity Grade
Refer to data sheet
Service Life
Condition dependent
Consistent Performance
Formulations are developed for stable viscosity, wear protection and contamination control across the stated operating range.
Optimized Formulation
Engineered for stable film strength and anti-wear performance, supporting longer service intervals where operating conditions and oil analysis allow.
Quality Assured
Manufactured under ISO 9001:2015 quality management system with full batch traceability and certificate of analysis.
Application Guide
Step-by-step instructions for optimal use of Valve Flush VF-3 in Oil & Gas applications.
Preparation
Ensure the application surface is clean, dry, and free from contaminants. Remove any existing lubricant residues using appropriate cleaning agents. For Oilfield valve maintenance applications, verify equipment is at operating temperature.
Application Method
Apply Valve Flush VF-3 using standard industrial equipment. For grease products, use automatic lubrication systems or manual grease guns. For liquid lubricants, ensure proper filling procedures and avoid contamination during transfer.
Recommended Dosage
Follow OEM recommendations for fill quantities. For Oil & Gas applications, typical re-lubrication intervals range from 1,000 to 5,000 operating hours depending on conditions. Monitor performance and adjust intervals based on actual operating parameters.
Performance Monitoring
Regularly inspect lubricant condition and equipment performance. Check for signs of degradation, contamination, or unusual wear. Schedule oil analysis every 6 months for critical applications to optimize maintenance intervals.
Storage Recommendations
- Store in a cool, dry place between 5°C and 35°C
- Keep containers sealed when not in use
- Avoid direct sunlight and moisture exposure
- Shelf life: 5 years from manufacture date when stored properly
Safety Information
- Refer to Safety Data Sheet (SDS) before use
- Use appropriate PPE: gloves and safety glasses
- Ensure adequate ventilation in application area
- Dispose of used lubricant according to local regulations
Related Products
Food Grade Lubricant FG-1
Food-grade lubricant specifically formulated for incidental contact with food products.
Silicone Grease S260
Premium silicone grease providing excellent dielectric properties and water resistance for electrical applications.
PTFE Spray Lubricant PTFE-200
Dry PTFE spray lubricant providing long-lasting lubrication without attracting dust or dirt.